Building permits in 90008

eplan NEW DETACHED ACCESSORY DWELLING UNIT PER LAMC 12.22 A.33(b)(1)3

(1/2) ePlan convert portion of (e) garage to 2 story 2 unit ADU per GC 66323(a)(4).

[ePlan]Supplemental permit to 24016-10000-10958 to revise previous approved set to "Change Of Use From Automotive repair garage to Restaurant" and Structural plan check for mechanical equipment at roof

ePlan New detached 2 car garage and attached recreation room with 1/2 bath

CONVERT (E) ENCLOSED PATIO TO BE PART OF THE (E) SFD WITH A NEW ADDITION

Eplan: Soft-Story seismic retrofit per LABC Chapter 93: SOFT STORY SEISMIC REINFORCEMENT AT BUILDING PARKING GARAGE USING (2) SPECIAL CANTILEVERED COLUMNS WITH (2) GRADE BEAMS PER LABC CHAPTER 93.

SUPPLEMENTAL TO PERMIT 26047-20000-00465 TO REVISE POOL/SPA DIMENSTIONS AND LAYOUT

EPLAN. ALTERATION TO APARTMENT BUILDING FOR BALCONY REPAIR AT FRONT SIDE OF THE BUILDING BY REMOVING PART OF THE BALCONY AND SISTERING THE ROTTED JOIST.

***Eplan *** **Supplemental permit to 24016-10000-09616 for Structural plan revision to accommodate mechanical equipment on roof on building.

22 window(s). Window and door change-out (same size & type) for residential buildings. Dual glazing, labeled and certified by National Fenestration Rating Council (NFRC), is required for doors and windows replaced in all residential buildings, three stories or less, per Title 24, Part 6, Section 150.2(b)1B.3 bathroom(s).Bathroom remodel for residential buildings (no structural changes).5 door(s). Window and door change-out (same size & type) for residential buildings. Dual glazing, labeled and certified by National Fenestration Rating Council (NFRC), is required for doors and windows replaced in all residential buildings, three stories or less, per Title 24, Part 6, Section 150.2(b)1B.Kitchen remodel for residential buildings (no structural changes).

1) Demolish portion of SFD and a new bedroom addition to existing 1 story SFD.

Re-roof with Class A or B roof covering material weighing less than 6 pounds per sq. ft. over existing solid sheathing ___22___Squares. Class A roof covering is required within Very High Fire Hazard Severity Zone (VHFHSZ). For residential roof replacement > 50% of the total roof area, apply Cool Roof Product labeled and certified by Cool Roof Rating Council (CRRC). Cool Roof may be required for non-residential buildings per Title 24, Part 6, Section 141.0(b)2B.

Re-roof with Class A or B roof covering material weighing less than 6 pounds per sq. ft. over new solid sheathing 28 Squares. Class A roof covering is required within Very High Fire Hazard Severity Zone (VHFHSZ). For residential roof replacement > 50% of the total roof area, apply Cool Roof Product labeled and certified by Cool Roof Rating Council (CRRC). Cool Roof may be required for non-residential buildings per Title 24, Part 6, Section 141.0(b)2B.

Install radiant barrier and/or insulation in attic for residential buildings.

Re-roof with Class A or B roof covering material weighing less than 6 pounds per sq. ft. over existing solid sheathing 25 Squares. Class A roof covering is required within Very High Fire Hazard Severity Zone (VHFHSZ). For residential roof replacement > 50% of the total roof area, apply Cool Roof Product labeled and certified by Cool Roof Rating Council (CRRC). Cool Roof may be required for non-residential buildings per Title 24, Part 6, Section 141.0(b)2B.

Fire damage repair for residential buildings only (maximum 10% of replacement cost of building).

SUPPLEMENTAL PERMIT TO 26014-10000-01656 TO ADD FOUNDATION DETAIL TO REMOVE AND REPLACE FOUNDATION ON THREE WALLS. ALL WORK PER WFPP.

ePan: Repair of Second-floor exterior elevated elements in compliance with SB721 requirements, which includes: repairing all rotted joists and strengthening loose railing connections.

ePlan: Repair of Second-floor exterior elevated elements in compliance with SB721 requirements, which includes: repairing all rotted joists as specified on the structural details. Also, strengthen the loose railing connection as shown on structural details.

Re-roof with Class A or B roof covering material weighing less than 6 pounds per sq. ft. over existing solid sheathing 22 Squares. Class A roof covering is required within Very High Fire Hazard Severity Zone (VHFHSZ). For residential roof replacement > 50% of the total roof area, apply Cool Roof Product labeled and certified by Cool Roof Rating Council (CRRC). Cool Roof may be required for non-residential buildings per Title 24, Part 6, Section 141.0(b)2B.